Seite 1 von 1

Lifting keel

Verfasst: Samstag 14. Mai 2011, 15:55
von mrnoorlander
Hello All,

I had my boat (Dehlya 22) frist time out of the water and I inspected the lifting keel. The intention was to take it out and service it. However, I did not match the details I found on the website and also items were missing. So I put it on hold for now hoping some one form the forum can give me some pointers before I continue

From photo's below you can see:
- The winch (on deck) looks different and I only see a locking pin that I can remove
- The fore and aft bearings (and their holders) are missing.

When I look into the keel box (past the keel and looking up) I only see the bolt on the end of the keel (turning) shaft.

Now I wander:
- Is this indeed as it should be as it looks different from the lifting keel pages on the website?
- Do I just remove the locking pin on deck and remove the bolt to lower and take out the keel completely?
- Which parts am I missing and where to buy them?

Hope some one can shine a light on this. Thank you

regards
michael
keel5.JPG
keel5.JPG (936.38 KiB) 8000 mal betrachtet
keel7.JPG
keel7.JPG (956 KiB) 8000 mal betrachtet

Re: Lifting keel

Verfasst: Sonntag 15. Mai 2011, 19:31
von mrnoorlander
Hello Again,

After once more checking the website tonight I did find the correct details of my lifting keel:
Hubkielausbau Dehlya 22 or www.phimax-trier.de

So one question left:
Any one an idea were you can buy the fore and aft keel bearings (incl. their brackets)?

Thank you.

Michael

Re: Lifting keel

Verfasst: Sonntag 15. Mai 2011, 22:57
von Dödel
Hello Michael,

would it be possible to try http://www.marina-grossenbrode.de/
marina-grossenbrode(at)t-online.de
?

Peter

Re: Lifting keel

Verfasst: Montag 16. Mai 2011, 07:28
von Claus_22
Hi Michael,

please get in contact with Theo Kordt.

http://www.ymh.de/

He is offering parts and services for dehlya boats.
I hope this helps.

Best regards,
Claus

Re: Lifting keel

Verfasst: Montag 16. Mai 2011, 11:17
von mrnoorlander
Thanks Peter / Claus,

Much appreciaced!
I will contact both

Reards
Michael